How to Install Silo Clock (with No-Drill Hanger)

How to Install Silo Clock (with No-Drill Hanger)

Sep 30, 2024

Installing a silo clock is an effortless task that can be accomplished in just a few minutes. With its user-friendly design and simple instructions, setting up a silo clock is a breeze for anyone. 

Key tips to know before installing the No Drill Hanger with 3M Command™  Hanging Strips:

  • Wait 28 days after painting before use. Do not apply strips to paper or soft surfaces.
  • Do not hang over beds or on wallpaper.
  • Use indoors 10ºC - 40.5ºC.
  • Wipe wall with rubbing alcohol. Do not use household cleaners or water.
  • Do not use on textured walls or surfaces, wallpaper, brick, rough or non-stick surfaces, or fabrics.

Step 01: Place the template

Fix the template to the wall firmly, ensuring it is straight, flat and without any creases.

Use removable tape to prevent surface damage.

Only install the markers on smooth and flat wall surfaces. Ensure that the lowest point of the bottom marker is taller than your kid’s height in case of an accident; also keep away all the small components from kid(s).

 

Step 02: Fix the markers

Remove the backing from the markers, and place in the desired location.

You can place 4 or 12 markers in either the large or the small diameter.

 

Step 03: Mark the hanger position

With a pencil, trace the outline of the hanger using the cutout in the template. This will help position the no-drill hanger once the template is removed.

 

Step 04: Remove the template 

Carefully remove the template, leaving the markers in place.

Take extra care to prevent surface damage.

 

Step 05: Apply the 3M strips to the hanger

Remove one side of liners. Stick them on the back of the hanger. Distribute the three strips evenly across the hanger, making sure the side facing the wall remains on the outside.

 

Step 06: Stick the hanger to the wall

Remove the remaining liners and use hanger marked position to center it.

Press the hanger firmly to wall for 30 seconds.

Wait 1 hour for the adhesive to build

 

Step 07: Remove the clock from the package

Never hold, handle or pull the clock away from the disc, always hold the movement case.

Failure to do so will damage the movement and void the warranty.

 

Step 07: Adjust the time

To adjust the time, use the time adjustment wheel located on the back of the movement.

Never adjust the time by pushing the hour or minute hands. Failure to do so will damage the clock. 

 

Step 08: Insert the battery

Insert x1 AA battery into the back of the clock. 

Use only high quality AA Battery, a low quality or expired battery could damage the clock and void the warranty. Please also avoid rechargeable battery.

We recommend using PANASONIC alkaline batteries

 

Step 09: Install the clock

Fix the clock to the hanger, ensuring the back is completely flush to the surface.

Always remember to hold the movement case, not the disk, when fixing the clock on the wall.

 

Step 10: Thanks!

 

 

 

 

 



Altri articoli