Installing a silo clock is an effortless task that can be accomplished in just a few minutes. With its user-friendly design and simple instructions, setting up a silo clock is a breeze for anyone.
Key tips to know before installing the No Drill Hanger with 3M Command™ Hanging Strips:
- Wait 28 days after painting before use. Do not apply strips to paper or soft surfaces.
- Do not hang over beds or on wallpaper.
- Use indoors 10ºC - 40.5ºC.
- Wipe wall with rubbing alcohol. Do not use household cleaners or water.
- Do not use on textured walls or surfaces, wallpaper, brick, rough or non-stick surfaces, or fabrics.
Step 01: Place the template
Use removable tape to prevent surface damage.
Only install the markers on smooth and flat wall surfaces. Ensure that the lowest point of the bottom marker is taller than your kid’s height in case of an accident; also keep away all the small components from kid(s).
Step 02: Fix the markers
Remove the backing from the markers, and place in the desired location.
You can place 4 or 12 markers in either the large or the small diameter.
Step 03: Mark the hanger position
With a pencil, trace the outline of the hanger using the cutout in the template. This will help position the no-drill hanger once the template is removed.
Step 04: Remove the template
Carefully remove the template, leaving the markers in place.
Take extra care to prevent surface damage.
Step 05: Apply the 3M strips to the hanger
Remove one side of liners. Stick them on the back of the hanger. Distribute the three strips evenly across the hanger, making sure the side facing the wall remains on the outside.
Step 06: Stick the hanger to the wall
Remove the remaining liners and use hanger marked position to center it.
Press the hanger firmly to wall for 30 seconds.
Wait 1 hour for the adhesive to build
Step 07: Remove the clock from the package
Never hold, handle or pull the clock away from the disc, always hold the movement case.
Failure to do so will damage the movement and void the warranty.
Step 07: Adjust the time
To adjust the time, use the time adjustment wheel located on the back of the movement.
Never adjust the time by pushing the hour or minute hands. Failure to do so will damage the clock.
Step 08: Insert the battery
Insert x1 AA battery into the back of the clock.
Use only high quality AA Battery, a low quality or expired battery could damage the clock and void the warranty. Please also avoid rechargeable battery.
We recommend using PANASONIC alkaline batteries
Step 09: Install the clock
Fix the clock to the hanger, ensuring the back is completely flush to the surface.
Always remember to hold the movement case, not the disk, when fixing the clock on the wall.
Step 10: Thanks!
